Welcome. Register now to see your pricing.
Close
Heat Shrink Tubing, 1 to 4/0 AWG, Clear, 6" Length, 1" ID Before and 0.4" ID After Shrinkage, 2.5:1 Shrink Ratio (Pack of 4)
Representative Image Only
• 2.5:1 shrink ratio
• Medium wall thickness fills the void between thin wall and heavy wall tubing
• Outer wall of tubing is high grade polyolefin with an inner wall of adhesive sealant
• Heat-activated sealant provides moisture-tight seal
• 6" lengths
• Meets MIL-1-23053/4 Specification
• Dielectric strength: 1,000V/mil
• Low-temperature flexibility: Four hours at –67°F (–55°C)
• Maximum continuous operating temperature: 230°F (110°C)
• Non-corrosive
• Non-nutrient – fungus resistant
• Excellent fluid resistance
• Rated at 600V
• Clear tubing allows visual inspection of wire and terminal• Tensile strength: 2,200 PSI• Elongation: 500%• Volume resistivity: 1015 Ohm/cm• Heat shock: Four hours at 482°F (250°C)• Longitudinal change: Less than 5%• Not flame-retardant• Secant modulus: 27,000 PSI
• Perfect for light-duty applications where heavy wall isn’t needed
• Use over wire markers for permanent identification
Wire gauge coverage is approximate due to the wide variance of wire thicknesses.
• 2.5:1 shrink ratio
• Medium wall thickness fills the void between thin wall and heavy wall tubing
• Outer wall of tubing is high grade polyolefin with an inner wall of adhesive sealant
• Heat-activated sealant provides moisture-tight seal
• 6" lengths
• Meets MIL-1-23053/4 Specification
• Dielectric strength: 1,000V/mil
• Low-temperature flexibility: Four hours at –67°F (–55°C)
• Maximum continuous operating temperature: 230°F (110°C)
• Non-corrosive
• Non-nutrient – fungus resistant
• Excellent fluid resistance
• Rated at 600V
• Clear tubing allows visual inspection of wire and terminal• Tensile strength: 2,200 PSI• Elongation: 500%• Volume resistivity: 1015 Ohm/cm• Heat shock: Four hours at 482°F (250°C)• Longitudinal change: Less than 5%• Not flame-retardant• Secant modulus: 27,000 PSI
• Perfect for light-duty applications where heavy wall isn’t needed
• Use over wire markers for permanent identification
Wire gauge coverage is approximate due to the wide variance of wire thicknesses.
