Band-It Clamp Basic Ratchet Tool 3/8-5/8 9-3/4"
(Pack of
1)
1. Insert clamp in tool, then insert wrench assembly. If you prefer, install wrench assembly before clamp is inserted.2. Start pumping ratchet wrench forward until proper tension has been applied.3. Place punch on clamp buckle and, while holding tension with ratchet wrench, lock clamp by striking punch with hammer until clamp is tight.4. While holding tension with wrench, swing tool up against buckle, then backward to break off clamp tail. To loosen clamp tail, wind until tail is free. Remove mandrel-wrench assembly.
Couldn't load pickup availability
California Proposition 65: WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov
Frequently Bought Together

One-Ear Stepless Hose Clamp 304 SS 0.228 to 0.275"
Couldn't load pickup availability

Constant Tension Hose Clamp 301 SS 5/8 to 15/16"
Couldn't load pickup availability

Super 77 Hose Clamp SS 3-1/2 to 4-3/8"
Couldn't load pickup availability

Brass DOT PTC 1/4 and 3/8 Assortment
Couldn't load pickup availability

Dual Pistol/Lever Handle Grease Gun
Couldn't load pickup availability

Grease Gun Holder
Couldn't load pickup availability

Hose Clamp 301 SS 2-13/16 to 3-3/4"
Couldn't load pickup availability

Band-It Clamp High-Carbon Steel 5 x 5/8"
Couldn't load pickup availability

Hose Clamp 301 SS 1-1/16 to 2"
Couldn't load pickup availability

Vacuum Hose Connector Straight 1/4 x 1/4"
Couldn't load pickup availability

Vacuum Hose Connector Straight 3/16 x 3/16"
Couldn't load pickup availability

Norma Torro European Hose Clamp 3/8 to 5/8"
Couldn't load pickup availability

Air Distributor Defroster Push-Type Retainer
Couldn't load pickup availability

Front Fender Push-Type Retainer Nylon 18mm
Couldn't load pickup availability

Nylon Cable Tie 11-3/4" Black
Couldn't load pickup availability
Product Description
1. Insert clamp in tool, then insert wrench assembly. If you prefer, install wrench assembly before clamp is inserted.2. Start pumping ratchet wrench forward until proper tension has been applied.3. Place punch on clamp buckle and, while holding tension with ratchet wrench, lock clamp by striking punch with hammer until clamp is tight.4. While holding tension with wrench, swing tool up against buckle, then backward to break off clamp tail. To loosen clamp tail, wind until tail is free. Remove mandrel-wrench assembly.Technical Specifications
Item#: | 81197 |
---|---|
Category | Band-It Clamp |
SAE Size | 3/8-5/8 |
Material | Basic Ratchet Tool |
Description | Form-Seal Tool |
Size | 3/8-5/8 " |
Length | 9-3/4 " |
UNSPSC #: | 31162906 |
TAA Compliant: | Yes |
Weight: | 0.96 lb |
Product Restrictions
California Proposition 65: WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov
