Wedge Type Anchor Bolt Steel 1/2 x 3-1/2"
(Pack of
10.0)
• Zinc-plated, rust-resistant steel
• Meets the following specifications: OSHA Section 1910.212 (b), I.C.B.O. No. 1821, GSA FFS-325 and ASTM B633
• Designed for installation in concrete block, brick and stone
1. Drill hole to depth equal to length of Wej-It® Anchor Bolt. Clean hole with compressed air and wire brush.
2. Drive Wej-It® Anchor Bolt into drilled hole through fixture until washer is flush with fixture.
3. Tighten the nut three to five turns past the hand-tight position.
Couldn't load pickup availability
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
Frequently Bought Together
Lag Screw Shield Anchor Long Style 3/8 x 2-1/2"
Couldn't load pickup availability
Double Expansion Shield Anchor Alloy Steel 5/8"
Couldn't load pickup availability
Masonry Sleeve Anchor Steel 1/4 x 2-1/4"
Couldn't load pickup availability
Hex Cap Screw Grade 8 Alloy Steel 5/8-18 x 2-1/2"
Couldn't load pickup availability
Hex Flange Bolt Grade 8 1/4-20 x 1"
Couldn't load pickup availability
Hex Flange Bolt Grade 10.9 M10-1.25 x 16mm
Couldn't load pickup availability
Front Bumper Drive Rivet Plastic 10mm Hole
Couldn't load pickup availability
Air Distributor Defroster Push-Type Retainer
Couldn't load pickup availability
Front/Rear Bumper Push-Type Retainer Nylon 20mm
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor Steel 5/8 x 3-1/2"
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor Steel 1/2 x 4-1/4"
Couldn't load pickup availability
Wedge Type Anchor Bolt Steel 3/8 x 2-3/4"
Couldn't load pickup availability
Product Description
• Zinc-plated, rust-resistant steel• Meets the following specifications: OSHA Section 1910.212 (b), I.C.B.O. No. 1821, GSA FFS-325 and ASTM B633
• Designed for installation in concrete block, brick and stone
1. Drill hole to depth equal to length of Wej-It® Anchor Bolt. Clean hole with compressed air and wire brush.
2. Drive Wej-It® Anchor Bolt into drilled hole through fixture until washer is flush with fixture.
3. Tighten the nut three to five turns past the hand-tight position.
Technical Specifications
| Item#: | 92860 |
|---|---|
| Diameter | 1/2 " |
| Length | 3-1/2 " |
| Thread Length | 1 " |
| Drill Size | 1/2 " |
| Material | Carbon Steel |
| Finish | Bright Zinc |
| Type | Wedge Anchor |
| Size | 1/2X3-1/2 " |
| Minimum Embedment | 2 " |
| UNSPSC #: | 31162101 |
| TAA Compliant: | No |
| Weight: | 2.26 lb |
Product Restrictions
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
