Drop-In Anchor Steel 1/4 x 1"
(Pack of
25)
An all-steel anchor
Use with standard bolts for flush mount applications in concrete or masonry
Designed to provide high holding strength with relatively shallow embedment depths
1. Drill hole 1/8" deeper than anchor length for flush mounting. Where surface deterioration is present, drill hole slightly deeper to permit anchor to be recessed.
2. Drop anchor into hole. If hole is slightly undersized, tap anchor with hammer until it bottoms in hole.
3. To set expander plug, installation tool can be struck a few sharp blows with a hammer, or an automatic air tool or electric tool can be used.
4. Place fixture in position, insert bolt and tighten.
Couldn't load pickup availability
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
Frequently Bought Together

Sleeve Type Stud Bolt Anchor Steel 5/16 x 3-1/2"
Couldn't load pickup availability

Double Expansion Shield Anchor Alloy Steel 5/16"
Couldn't load pickup availability

Sleeve Type Stud Bolt Anchor Steel 5/8 x 4-1/4"
Couldn't load pickup availability

Drop-In Anchor Steel 3/8 x 1-9/16"
Couldn't load pickup availability

Drop-In Anchor High Strength 1/2-13 x 3-5/8"
Couldn't load pickup availability

Drop-In Anchor High Strength 3/8-16 x 2-3/4"
Couldn't load pickup availability

Hex Nut Grade 8 Steel M6-1
Couldn't load pickup availability

Hex Nut Grade 8 Steel M12-1.75
Couldn't load pickup availability

Hex Nut Grade 8 Steel M10-1.5
Couldn't load pickup availability

Radiator Grille Nut M4.2-1.41
Couldn't load pickup availability

Bumper Drive Rivet Plastic 10mm Hole
Couldn't load pickup availability

Fender Splash Shield Retainer Nylon 20mm
Couldn't load pickup availability
Product Description
An all-steel anchor Use with standard bolts for flush mount applications in concrete or masonry
Designed to provide high holding strength with relatively shallow embedment depths
1. Drill hole 1/8" deeper than anchor length for flush mounting. Where surface deterioration is present, drill hole slightly deeper to permit anchor to be recessed.
2. Drop anchor into hole. If hole is slightly undersized, tap anchor with hammer until it bottoms in hole.
3. To set expander plug, installation tool can be struck a few sharp blows with a hammer, or an automatic air tool or electric tool can be used.
4. Place fixture in position, insert bolt and tighten.
Technical Specifications
Item#: | 96952 |
---|---|
Diameter | 1/4 " |
Overall Length | 1 " |
Type | Expansion Drop-In Anchor |
Drill Size | 3/8 " |
Allowable Tension (4,000 psi Concrete) | 418 lb |
Allowable Shear (4,000 psi Concrete) | 495 lb |
UNSPSC #: | 31162101 |
TAA Compliant: | No |
Weight: | 0.51 lb |
Product Restrictions
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
