1/4x3 Mas-Tap Hd Anchor
(Pack of
10.0)
• One-piece heavy-duty anchor with sharp aggressive concrete cutting threads
• Easy to install and can be removed
• Serrated teeth under the head grip to installed fixtures
• Steel thread design provides a keyed engagement and allows for reduced spacing and edge distances
• Can be used in a variety of solid masonry materials such as concrete, brick, stone, and block
• Works with standard properly sized masonry drill bits, no special bit required
• Zinc-plated case hardened low carbon steel
1. Check specs to determine proper anchor.
2. Drill hole to proper depth. Then remove dust and debris.
3. Place anchor through fixture and into hole and begin tightening.
4. Tighten until anchor head is tightly seated against fixture.
Frequently Bought Together
Drop-In Anchor Steel 1/2 x 2"
Couldn't load pickup availability
Masonry Anchor Hex Washer Head Steel 5/16 x 1-3/4"
Couldn't load pickup availability
Masonry Anchor Phillips Head #14-10 x 2-1/4"
Couldn't load pickup availability
Hex Flange Bolt Grade 10.9 M10-1.25 x 16mm
Couldn't load pickup availability
Hex Flange Bolt Grade 10.9 M10-1.25 x 20mm
Couldn't load pickup availability
Hex Flange Bolt Grade 10.9 M8-1.25 x 12mm
Couldn't load pickup availability
Masonry Anchor TORX® Head Steel 3/16 x 3-3/4"
Couldn't load pickup availability
3/16X1-1/4 Chrome Ez-One Square Pan Hd
Couldn't load pickup availability
Masonry Anchor Hex Washer Head Steel 3/16 x 2-3/4"
Couldn't load pickup availability
Metric Indented Hex Head Bolt with 17mm Washer
Couldn't load pickup availability
Radiator Grille Nut M4.2-1.41
Couldn't load pickup availability
Fender Splash Shield Retainer Nylon 20mm
Couldn't load pickup availability
Product Description
• One-piece heavy-duty anchor with sharp aggressive concrete cutting threads• Easy to install and can be removed
• Serrated teeth under the head grip to installed fixtures
• Steel thread design provides a keyed engagement and allows for reduced spacing and edge distances
• Can be used in a variety of solid masonry materials such as concrete, brick, stone, and block
• Works with standard properly sized masonry drill bits, no special bit required
• Zinc-plated case hardened low carbon steel
1. Check specs to determine proper anchor.
2. Drill hole to proper depth. Then remove dust and debris.
3. Place anchor through fixture and into hole and begin tightening.
4. Tighten until anchor head is tightly seated against fixture.
Technical Specifications
| Item#: | DY09991349 |
|---|---|
| Diameter | 1/4 " |
| Length | 3 " |
| Type | Screw Anchor |
| Material | Carbon Steel |
| Minimum Embedment | 1 " |
| Finish | Zinc |
| Drive | 7/16 " |
| Drill Size | 1/4 " |
| Head Style | Hex |
| Drive Style | 7/16 " |
| Minimum Hole Depth | 1-3/8 " |
| UNSPSC #: | 31162104 |
| TAA Compliant: | No |
| Weight: | 0.58 lb |
