3/4x5 Mas-Tap HD Hex Head Concrete Screw Anchor
(Pack of
5)
One-piece heavy-duty anchor with sharp aggressive concrete cutting threads
Easy to install and can be removed
Serrated teeth under the head grip to installed fixtures
Steel thread design provides a keyed engagement and allows for reduced spacing and edge distances
Can be used in a variety of solid masonry materials such as concrete, brick, stone, and block
Works with standard properly sized masonry drill bits, no special bit required
Zinc-plated case hardened low carbon steel
1. Check specs to determine proper anchor.
2. Drill hole to proper depth. Then remove dust and debris.
3. Place anchor through fixture and into hole and begin tightening.
4. Tighten until anchor head is tightly seated against fixture.
Frequently Bought Together

Masonry Anchor Assortment 243Pcs
Couldn't load pickup availability

Wallboard Anchor Assortment 1125Pcs
Couldn't load pickup availability

Masonry Anchor Assortment 243Pcs
Couldn't load pickup availability

Hex Flange Nut Grade 8 Steel M8-1.25
Couldn't load pickup availability

Sheet Metal Screw Phillips Truss Head #14 x 3/4"
Couldn't load pickup availability

Hex Nut Grade 5 Steel 3/8-16
Couldn't load pickup availability

Masonry Anchor Hex Washer Head Steel 5/16 x 2-3/4"
Couldn't load pickup availability

Masonry Anchor Phillips Head #14-10 x 1-3/4"
Couldn't load pickup availability

1/2x3 Mas-Tap Hd Anchor
Couldn't load pickup availability

Front/Rear Bumper Push-Type Retainer Nylon 20mm
Couldn't load pickup availability

Nylon Cable Tie 11-3/4" Black
Couldn't load pickup availability

Miniature Incandescent Bulb 12V 2CP
Couldn't load pickup availability
Product Description
One-piece heavy-duty anchor with sharp aggressive concrete cutting threads Easy to install and can be removed
Serrated teeth under the head grip to installed fixtures
Steel thread design provides a keyed engagement and allows for reduced spacing and edge distances
Can be used in a variety of solid masonry materials such as concrete, brick, stone, and block
Works with standard properly sized masonry drill bits, no special bit required
Zinc-plated case hardened low carbon steel
1. Check specs to determine proper anchor.
2. Drill hole to proper depth. Then remove dust and debris.
3. Place anchor through fixture and into hole and begin tightening.
4. Tighten until anchor head is tightly seated against fixture.
Technical Specifications
Item#: | DY09993357 |
---|---|
Diameter | 3/4 " |
Length | 5 " |
Type | Screw Anchor |
Material | Carbon Steel |
Minimum Embedment | 2-1/2 " |
Finish | Zinc |
Drive | 1-1/8 " |
Drill Size | 3/4 " |
Head Style | Hex |
Drive Style | 1-1/8 " |
Minimum Hole Depth | 2-7/8 " |
UNSPSC #: | 31162104 |
TAA Compliant: | Yes |
Weight: | 4.14 lb |
Product Restrictions
