Terminal Crimping Tool with Interchangeable Die, 26-16 AWG, Full Cycle Ratchet, Suitable for Open Barrel Non-Insulated Terminals
(Pack of
1)
• Professional tool incorporating a single frame with several interchangeable dies
• Full cycle ratchet with safety release
• High-quality electrical and mechanical crimps are made simultaneously
• Crimps meet or exceed industry standards
• Assures a positive mechanical and electrical crimp and ease of use
• Crimping dies can be easily switched with two screws
The die will slide out towards the front of the frame simply by loosening the two socket head screws and removing them.
To replace the die1. Simply extend the frame to its full open position.2. Close the frame approximately halfway. 3. Insert the die into the frame until it stops. All dies can be inserted only one way for the tool to close properly.4. Tighten the screws approximately halfway. 5. Close the frame to press the dies against each other. This helps to align the dies in the frame.6. Finish tightening the screws. 7. Frame and tool are complete and ready for use.
Frequently Bought Together
Selectakrimp™ Hand Crimping Tool 6-4/0 AWG
Couldn't load pickup availability
Hand Hydraulic Cable Crimper Set With Dies And Case
Couldn't load pickup availability
Terminal Crimping Tool with Die 22-10 AWG
Couldn't load pickup availability
Crimping Tool 26-10 AWG
Couldn't load pickup availability
Pin and Socket Extractor Tool
Couldn't load pickup availability
O-Ring Repair Kit
Couldn't load pickup availability
Twist-On Holding Pad 30000rpm 2"
Couldn't load pickup availability
Abrasive Roll Kit 2" x 15'
Couldn't load pickup availability
Wire Harness Connector Release Tool
Couldn't load pickup availability
Front Fender Liner Push-Type Retainer Nylon 20mm
Couldn't load pickup availability
High-Tech Seam Sealer Clear 5fl.oz
Couldn't load pickup availability
Shield Push-Type Retainer with Metal Insert
Couldn't load pickup availability
Razor Blade Single Edge w/Notch
Couldn't load pickup availability
0.5 HP Reciprocating Air Saw
Couldn't load pickup availability
Pneumatic Impact Wrench, 1/2 Drive Max Torque 730 lbs
Couldn't load pickup availability
Product Description
• Professional tool incorporating a single frame with several interchangeable dies• Full cycle ratchet with safety release
• High-quality electrical and mechanical crimps are made simultaneously
• Crimps meet or exceed industry standards
• Assures a positive mechanical and electrical crimp and ease of use
• Crimping dies can be easily switched with two screws
The die will slide out towards the front of the frame simply by loosening the two socket head screws and removing them.
To replace the die1. Simply extend the frame to its full open position.2. Close the frame approximately halfway. 3. Insert the die into the frame until it stops. All dies can be inserted only one way for the tool to close properly.4. Tighten the screws approximately halfway. 5. Close the frame to press the dies against each other. This helps to align the dies in the frame.6. Finish tightening the screws. 7. Frame and tool are complete and ready for use.
Technical Specifications
| Item#: | 95111 |
|---|---|
| Type | Crimping Tool |
| Style | Terminal Connector Crimping System |
| Crimp Range | 22-10 AWG |
| Description | Tool with 95106 Die |
| UNSPSC #: | 27111500 |
| TAA Compliant: | Yes |
| Weight: | 1.86 lb |
