Wedge Type Anchor Bolt, Steel, Zinc Finish, 3/8 x 3-1/2"
(Pack of
25)
SKU:92857 Item#: 92857
• Zinc-plated, rust-resistant steel
• Meets the following specifications: OSHA Section 1910.212 (b), I.C.B.O. No. 1821, GSA FFS-325 and ASTM B633
• Designed for installation in concrete block, brick and stone
1. Drill hole to depth equal to length of Wej-It® Anchor Bolt. Clean hole with compressed air and wire brush.
2. Drive Wej-It® Anchor Bolt into drilled hole through fixture until washer is flush with fixture.
3. Tighten the nut three to five turns past the hand-tight position.
Frequently Bought Together
Double Expansion Shield Anchor Alloy Steel 5/8"
$0.00
Couldn't load pickup availability
Masonry Sleeve Anchor Steel 1/4 x 2-1/4"
$0.00
Couldn't load pickup availability
Masonry Anchor Hex Washer Head Steel 1/4 x 1"
$0.00
Couldn't load pickup availability
Sheet Metal Screw Phillips Truss Head #14 x 3/4"
$0.00
Couldn't load pickup availability
Self-Drilling Screw Hex Head 1/4-14 x 1-1/4"
$0.00
Couldn't load pickup availability
DIN 9021B Fender Washer Low Carbon Steel 18mm
$0.00
Couldn't load pickup availability
Molding Clip with Sealer Nylon White 11.5 x 21
$0.00
Couldn't load pickup availability
Front Rear Bumper Specialty Rivet 3.2mm
$0.00
Couldn't load pickup availability
Push-Type Retainer Nylon 20mm
$0.00
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor Steel 1/4 x 1-3/4"
$0.00
Couldn't load pickup availability
Wedge Type Anchor Bolt Steel 3/4 x 4"
$0.00
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor Steel 5/8 x 8-1/2"
$0.00
Couldn't load pickup availability
Product Description
• Zinc-plated, rust-resistant steel• Meets the following specifications: OSHA Section 1910.212 (b), I.C.B.O. No. 1821, GSA FFS-325 and ASTM B633
• Designed for installation in concrete block, brick and stone
1. Drill hole to depth equal to length of Wej-It® Anchor Bolt. Clean hole with compressed air and wire brush.
2. Drive Wej-It® Anchor Bolt into drilled hole through fixture until washer is flush with fixture.
3. Tighten the nut three to five turns past the hand-tight position.
Technical Specifications
| Item#: | 92857 |
|---|---|
| Diameter | 3/8 " |
| Length | 3-1/2 " |
| Thread Length | 7/8 " |
| Drill Size | 3/8 " |
| Material | Carbon Steel |
| Finish | Bright Zinc |
| Type | Wedge Anchor |
| Size | 3/8X3-1/2 " |
| Minimum Embedment | 1-1/2 " |
| UNSPSC #: | 31162101 |
| TAA Compliant: | No |
| Weight: | 3.0 lb |
