Coolant Hose 1-1/4X5
(Pack of
1)
SKU:99679 Item#: 99679
• EPDM tube and cover
• Reinforced with single wire helix, two-ply synthetic fabric for pressure or vacuum service
• Resistant to heat, mild oil, chemicals, ozone and abrasion
• Extremely flexible and light weight
• Temperature range: –30°F to +240°F (–34°C to +115°C)
• Ideal marine utility hose (non-oily environment) – meets or exceeds USCG requirements for marine wet exhaust
• Useful in wastewater, industrial, construction and agricultural applications
Hold hose firmly and cut straight through to contact with spring steel wire. Do not cut wire.
Pull both ends apart about three inches to expose wire.
Grasp end to be used and snip wire slightly with wire cutters inside the end to be used. This cut should be close enough so that wire end does not protrude.
To install hose, twist slightly when placing over fitting. Apply to both fittings before clamping. We recommend the use of screw-type clamps. Do not use self-tightening clamps.
Frequently Bought Together
Bumper Push-Type Retainer Nylon 18mm
$0.00
Couldn't load pickup availability
Bumper Radiator and Grille Drive Rivet 7mm Hole
$0.00
Couldn't load pickup availability
Push-Type Retainer Nylon 16 x 19mm
$0.00
Couldn't load pickup availability
Product Description
• EPDM tube and cover• Reinforced with single wire helix, two-ply synthetic fabric for pressure or vacuum service
• Resistant to heat, mild oil, chemicals, ozone and abrasion
• Extremely flexible and light weight
• Temperature range: –30°F to +240°F (–34°C to +115°C)
• Ideal marine utility hose (non-oily environment) – meets or exceeds USCG requirements for marine wet exhaust
• Useful in wastewater, industrial, construction and agricultural applications
Hold hose firmly and cut straight through to contact with spring steel wire. Do not cut wire.
Pull both ends apart about three inches to expose wire.
Grasp end to be used and snip wire slightly with wire cutters inside the end to be used. This cut should be close enough so that wire end does not protrude.
To install hose, twist slightly when placing over fitting. Apply to both fittings before clamping. We recommend the use of screw-type clamps. Do not use self-tightening clamps.
Technical Specifications
| Item#: | 99679 |
|---|---|
| Type | Coolant Hose |
| I.D. | 1-1/4 " |
| Hose O.D. | 1-17/32 " |
| Bend Radius | 3 " |
| Working Pressure | 80 PSI |
| Burst Pressure | 320 PSI |
| Length | 5 ft |
| Recommended Hose Clamp | 86728 |
| Description | To be Discontinued - No volume |
| UNSPSC #: | 25170000 |
| TAA Compliant: | Yes |
| Weight: | 2.0 lb |
