Band-It Clamp High-Carbon Steel 2-3/4 x 5/8"
(Pack of
10.0)
• Made of high-carbon electrolytic galvanized steel to resist corrosion• 1/32" thick band
• Designed for industrial and production equipment
1. Insert clamp in tool, then insert wrench assembly. If you prefer, install wrench assembly before clamp is inserted.2. Start pumping ratchet wrench forward until proper tension has been applied.3. Place punch on clamp buckle and, while holding tension with ratchet wrench, lock clamp by striking punch with hammer until clamp is tight.4. While holding tension with wrench, swing tool up against buckle, then backward to break off clamp tail. To loosen clamp tail, wind until tail is free. Remove mandrel-wrench assembly.
Frequently Bought Together
Silicone Heater/Coolant Hose Clamp 13/16 to 1-1/2"
Couldn't load pickup availability
T-Bolt Hose Clamp SS 4-1/4 to 4-9/16"
Couldn't load pickup availability
Non-Perforated Clamp 316 SS #96 5 to 6-1/2"
Couldn't load pickup availability
H353H Truck Hose 1-15/64" OD x 50'
Couldn't load pickup availability
Parker DOT Compression - Nylon Male Branch Tee 3/8x1/4x1/4
Couldn't load pickup availability
DOT Transmission Connector Male Brass 1/16 x 5/32"
Couldn't load pickup availability
Super 77 Hose Clamp SS 3-1/2 to 4-3/8"
Couldn't load pickup availability
Silicone Heater/Coolant Hose Clamp 3-9/16 - 4-1/2"
Couldn't load pickup availability
H213 Truck Hose 31/64" OD x 50'
Couldn't load pickup availability
Hose End Brass 3/8 x 3/8"
Couldn't load pickup availability
Ergonomic Blowgun 1/4"
Couldn't load pickup availability
Ergonomic Blow Gun Rubber Tip
Couldn't load pickup availability
Wheel Flare Molding Clip with Sealer Nylon
Couldn't load pickup availability
Sheet Metal Drill Bit Alloy Steel 1/8"
Couldn't load pickup availability
Push-Type Retainer Nylon 20mm
Couldn't load pickup availability
Product Description
• Made of high-carbon electrolytic galvanized steel to resist corrosion• 1/32" thick band• Designed for industrial and production equipment
1. Insert clamp in tool, then insert wrench assembly. If you prefer, install wrench assembly before clamp is inserted.2. Start pumping ratchet wrench forward until proper tension has been applied.3. Place punch on clamp buckle and, while holding tension with ratchet wrench, lock clamp by striking punch with hammer until clamp is tight.4. While holding tension with wrench, swing tool up against buckle, then backward to break off clamp tail. To loosen clamp tail, wind until tail is free. Remove mandrel-wrench assembly.
Technical Specifications
| Item#: | 81193 |
|---|---|
| Category | Band-It Clamp |
| Material | Galvanized High-Carbon Steel |
| Size | 2-3/4 " |
| I.D. | 2-3/4 " |
| Minimum Diameter | 2-3/4 " |
| Band Width | 5/8 " |
| Width | 5/8 " |
| Thickness | 1/32 " |
| UNSPSC #: | 31162906 |
| TAA Compliant: | Yes |
| Weight: | 1.32 lb |
Product Restrictions
